![]() Try to flash back original firmware or openwrt firmware again (if possible).įirst I would try if tup can still be reached. Your description sounds to me that the device is bricked and flash failed as you cannot obtain any IP. So I can only provide general help nothing specific. I have no clue about the device and it's specific clips to get openwrt on it. ![]() It'll reboot by itself and be normal out-of-the-Edimax-box any minute. It will give you a message telling you how many bytes it transferred It will stay that way for over 20 minutes, no rush!įollow the TFTP recovery instructions from there, ie: All of the LEDs will light up solid when it's ready. You'll see the LEDs light and start flashing, then release the reset button. I'm honestly not sure if the firmware is simply not working or if I'm doing it wrong, but I'm starting to think it's the former.įor the record and future searchers, there aren't instructions recovering the original firmware, so here they are in TL DR form:Ĭonfigure the workstation to have IP 192.168.1.11, subnet mask 255.0.0.0 (/8), gateway 192.168.1.6ĭisconnect power to the AP, hold the reset button in, and connect the power. It's negotiating the ethernet connection to the correct 1Gbps but I'm not seeing any ethernet traffic at all. I've done each of those on each of the ethernet ports (in case only one was actually active). The AP isn't attempting to obtain an address via DHCP (ran packet capture on the server), and I've tried connecting with a workstation connected directly with hardcoded addresses in the 192.168.1.1/24 and 192.168.2.1/24 networks (I saw doco with either 1 or 2 as the third octet so I tried both), as well as the last address/network it had prior to the install (since the thing seems to retain a lot of settings through the install). I've installed OpenWRT to this new AP (because the stock firmware left a lot to be desired), following the instructions to reset to factory defaults and upload via the web interface, and after the device reboots there's no network connection to SSH into it. TL DR can't SSH no IP address to hit, pls help. It's 6am and I'm 12 hours into failing, I think it's time I asked for help Hi all, I'm new around here so forgive me if I'm missing something obvious.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |